Grand Canyon Gas Logs GlowFire® Series
GlowFire®logs bring the authentic warmth and realism that make Grand Canyon Gas Logs fireplaces stand out. Over time, normal use can cause light soot or dust buildup that may affect appearance and performance. Fortunately, cleaning GlowFire®logs is simple and safe when done correctly.
This guide will walk you through each step, from blowing off soot to inspecting for damage, so your fireplace continues to perform beautifully for years to come.
What You’ll Need
Before you begin, gather the following tools and materials:
- Soft bristle brush (nylon or paintbrush style)
- Compressed air (low pressure, under 30 psi)
- Shop vacuum with fine dust or HEPA filter
- Microfiber or lint-free cloth
- Mild dish soap (for heavier soot or oily residue)
- Distilled water
- Nitrile (powder free) gloves (to prevent oils from your hands transferring to the logs)
Cleaning Procedure
Power Down and Cool the System
Always begin with safety. Turn off all power to the GlowFire®system, including the ignition and solenoid circuits. Allow the logs and surrounding media to cool for at least 60 minutes before handling.
Blow Off and Capture Soot
Before touching the logs, visually inspect that all nickel fibers are securely attached and not lifting or frayed. Do not proceed with cleaning if fibers appear loose or detached, damaged fibers should be replaced before cleaning and operating the fireplace. Once confirmed, use low-pressure compressed air to gently blow away loose soot or dust. At the same time, position a shop vacuum near the work area to capture airborne particles as you clean. This two-step process minimizes mess and prevents soot from resettling on nearby components. Avoid scraping or rubbing the refractory surface, as this can damage the finish.
If Additional Cleaning Is Required
If stubborn soot or dark areas remain:
- Use a soft bristle brush or microfiber cloth lightly dampened with distilled water to gently loosen soot.
- Repeat several passes with light pressure rather than scrubbing.
- Allow the surface to air-dry before evaluating the results.
Do not soak the panels or logs. Moisture can be absorbed into the concrete, leaving temporary dark spots that fade as the surface dries.
Wet Cleaning (if needed)
If heavier buildup remains, mix a small amount of mild dish soap with distilled water.
Lightly dampen a microfiber cloth and wipe the affected areas.
Do not soak or immerse the logs — excessive moisture can harm internal materials.
For stubborn deposits, use a very small amount of isopropyl alcohol on a cloth.
Dry Thoroughly
Allow the logs to air dry completely, ideally overnight.
Never reinstall or operate the system while any component is still damp — trapped moisture can cause the logs to crack.
Logs with visible cracks may be unsafe to use and should be replaced.
Inspect and Reinstall
Before reinstalling, inspect each log for cracks, surface damage, or fiber separation.
Replace any damaged logs before relighting the system.
Reinstall the logs in their original positions within the burner pan.
Safety Reminders
- Never use air pressure above 30 psi.
- Avoid metal brushes, solvents, bleach, or degreasers.
- Do not clean while the fireplace is connected to power or gas supply.
- Only handle logs when they are cool to the touch.
- Always use gloves.
- Use eye protection when using compressed gas.
Why Regular Cleaning Matters
Routine cleaning not only enhances the beauty of your GlowFire®system but also helps ensure consistent ignition and balanced flame patterns.
Keeping soot and dust under control reduces the risk of odor, discoloration, and premature component wear. By following these guidelines, your Grand Canyon Gas Logs – GlowFire®Series log set will continue to deliver the rich glow, warmth, and reliability you expect for years to come.
